131
Running an Injector Program
Saving the Method
6 Select the Settings button [F1].
7 Select Autosampler from the menu.
8 Select the Inj.Program button [F3] to display the Program screen.
9 For program line 1, select the Insert button [F7].
10 Select the DRAW function and enter the draw settings as described in Table 4.
11 Select the Enter button [F7] to accept entries.
12 Repeat the procedure for the other functions to complete the program.
13 Press the Esc key until you are back in the Settings screen.
Injector Program Lines
Table 4 on page 132 describes the program lines which will complete the required
derivatization reaction.
Saving the Method
1 Select the Method button [F3] in the Analysis screen.
2 Select the Save As button [F8].
3 Enter the method name as DERIV using the selection keys (also see “Specifying a
Method Name” on page 39)
4 Press the Done button [F6] to save the method.
5 Press the Esc key to return to the Analysis screen.
The injector program is now part of the method called DERIV and can be started by
selecting the Start button [F8] in the Analysis screen.
To Next Page
Loading...
Need help?
General
