AC Line Power Supply Requirements Installation and Maintenance
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave
Multichannel System, Fourth Edition
203
cabinet, it must be disconnected from the line power by the system’s line power
switch.
CAUTION Please note that the power key on the front panel of the Agilent 8166A Lightwave
Multichannel System does not stop the flow of power to the instrument. The
power key allows you to switch between stand-by mode and power-on mode.
If you need to turn off the power, unplug the instrument at the mains or remove
the power cable connector from the appliance coupler at the rear of the
instrument. For this reason, the power cable connection should be easily
accessible - allowing you to turn off the power quickly. If the instrument is in a
cabinet, it must be disconnected from the line power by the system’s line power
switch.
The type of power cable shipped with each instrument depends on the country of
destination. Refer to Figure 150 for the part numbers of the power cables
available.
NOTE You only need to use the line power cable to connect to the AC adapter.
WARNING To avoid the possibility of injury or death, you must observe the following
precautions before switching on the instrument.
Figure 149 Agilent 8166A Lightwave Multichannel System Power Key
Figure 150 Line Power Cables – Plug Identification
To Next Page
Loading...
Need help?
General
