Agilent Technologies 8163A - Page 26

Figures
26 Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement
System, & Agilent 8166A Lightwave Multichannel System, Fourth Edition
Figure 159 How to Remove a Front-Loadable Module . . . . . . . . 210
Figure 160 How to Insert a Front-Loadable Module . . . . . . . . . 211
Figure 161 Back Panel of Agilent 8164A Lightwave Measurement System . . . 212
Figure 162 Side View of a Back-Loadable Module . . . . . . . . . 212
Figure 163 Removing a Back-Loadable Module from the Agilent 8164A . . . . 213
Figure 164 Fitting a Back-Loadable Module . . . . . . . . . . 214
Figure 165 Adding a Connector Interface . . . . . . . . . . . 215
Figure 166 Fitting a Blind Panel . . . . . . . . . . . . . 216
Figure 167 Rear Panel of the Agilent 8163A Lightwave Multimeter System . . . 217
Figure 168 Rear Panel of the Agilent 8164A Lightwave Measurement System . . . 217
Figure 169 Rear Panel of the Agilent 8166A Lightwave Multichannel System . . . 218
Figure 170 GPIB Connector . . . . . . . . . . . . . . 219
Figure 171 Mainframe Setup . . . . . . . . . . . . . . 249
Figure 172 Firmware Upgrade Flow Chart . . . . . . . . . . . 288