Chapter 5 237
Post-Repair Procedures
Manual Test, Adjustment, and Configuration Procedures
Manual Test, Adjustment, and Configuration
Procedures
Each of the following test, adjustment, and configuration procedures
includes all of the information required to complete the procedure. The
information includes—as applicable—a description of what the
procedure does, a list of equipment required for the execution, an
illustration of the equipment setup, and the steps necessary to complete
the procedure. They are designed to be run on an instrument operating
within a temperature range of 20 °C to 30 °C.
The following is a list of the procedures included in this section:
“Internal Front Panel Test” on page 238
“External Keyboard Test” on page 239
“Configuring a Replacement CPU Assembly” on page 241
“Configuring a Replacement Flash Memory Assembly” on page 244
“Internal 10 MHz Frequency Reference Adjustment” on page 248
“Internal 50 MHz Calibrator Adjustment” on page 250
“Burst Trigger Check” on page 254
“Baseband I/Q Amplitude Accuracy Test” on page 255
“Using the Alpha Editor Menu” on page 258
“Front Panel Test” on page 259
To Next Page
Loading...
Need help?
General
