258 Chapter 5
Post-Repair Procedures
Using the Alpha Editor Menu
Using the Alpha Editor Menu
The alpha editor enables you to enter text. All text entries are displayed
in the active function area.
1. When you access the alpha editor, you will see the menu that is
shown in Level 1 Menu of the table above.
2. If you wish to enter a capital letter, press the key which contains
the letter you wish to select. For example, if you want to enter an
upper case Y, you will press
VWXYZ. A submenu, as shown in the
example column of the table above, is now activated. You will then
press the softkey labelled
Y, and it will appear in the active function
area. To access lower case letters, press
More until (2 of 3) is
displayed. To access mathematical symbols and punctuation marks,
press
More until (3 of 3) is displayed.
3. Press
Return to return to the previous menu without entering
characters.
4. To enter a space, press
Space, which is available on both the letters
and the symbols menus.
5. If you need to correct a character you have entered, you can use the
backspace key to move the cursor in the active function area to the
character you need to correct. Then select the new character.
6. Once you have completed entering all characters, press
Done.
7. Pressing
ESC at any time prior to pressing Done will clear the new
entry and leave the previous entry unchanged.
Level 1 Menu Level 2 Menu Level 3 Menu Example
A B C D E F G a b c d e f g ( ) : ; , ’ V
H I J K L M N h i j k l m n _ ! ? ~ W
O P Q R S T U o p q r s t u + - * / < > = X
V W X Y Z v w x y z | / \ { } [ ] Y
Done Done @ # $ % ^ & Z
Space Space Space
More (1 of 3) More (2 of 3) More (3 of 3)
To Next Page
Loading...
Need help?
General
