Agilent Technologies FieldFox N9913A - Date and Time Settings; LAN Settings

184 FieldFox User’s Guide
o Calibration properties
o All settings tables
o Limit line tables
o All saved .png files
o Any of the following will re-display frequency information:
o Set to None, Preset, Mode Preset, or FieldFox restart.
Date and Time, Format, and Time Zone Settings
Set the local date and time, Date and Time format, and Time Zone that is shown
on the FieldFox screen. The Date and Time is also used to identify files that are
saved.
The Date and Time can also be set by synchronizing with GPS satellites. Learn
more on page 179.
NOTE
Because of licensing security, the Date and Time setting is restricted as follows:
 Can be set backward no more than 6 hours at a time.
 Can be set forward any amount of time.
 Can be set backward or forward no more than once in a day. A new day
begins at midnight.
The GPS Sync setting has the same restrictions.
There is no restriction for setting the Time Zone.
To change the Date and Time backward a significant amount, send an email to
ctd-soco_support@agilent.com.
TIP
BEFORE setting the Date and Time, be absolutely certain that the Time Zone
setting is correct.
How to set Date and Time, Date and Time Format, and Time Zone
 Press System 7.
 Then System Configuration.
 Then Date and Time.
 Press the ▲|▼ arrows to highlight the row to be edited.
 Then press Edit.
 Use the ▲|▼ arrows or rotary knob to select the field to be edited.
 Use the ▲|▼ arrows or numeric keypad to edit that field.
 Press Cancel or Done when the edits are complete.
 Press Done to exit the Date and Time settings. The readout in the upper-right
corner of the FieldFox screen will update accordingly.
LAN Settings
Configure the LAN settings to be used to communicate with the Data Link
Software. Learn more at: http://na.tm.agilent.com/fieldfox/datalink_info.html.