Agilent Technologies FieldFox N9913A - How to Record a Session; How to Playback a Session

122 FieldFox User’s Guide
How to Record a Session
 Press Trace 6
 Then Record Playback Setup
 Optionally set resolution (points). Learn how on page 98. This can NOT be
changed after a session is opened.
 Then either:
o New Session OR
o Recall Session then Open and select a session.
 Then Recorder Player
 Then Record
REC is displayed in the left of screen graticules.
During recording, choose from the following:
 Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording.
 Stop Immediately stops recording. Then choose from the following:
o Press Play to start replaying the recording from the beginning.
o Press Record to continue recording.
 User Tag Press to insert a User Tag at the current recorded trace. This allows
you to quickly move to this location during playback. Learn more in About
State and User Tags on page 121.
How to Playback a Session
 Press Trace 6
 If the session is already open, skip the following step. Otherwise:
 Then Record Playback Setup
o Press Recall Session Then select a session to playback and press Open.
 Then Recorder Player
 Then Play
PLAY is displayed in the left of screen graticules during playback. When the end
of the recording is reached, playback begins again at trace 1 and continues to
loop indefinitely.
During playback, choose from the following:
 Pause Resume Temporarily halts playback. Then choose from the following:
o Pause Resume Press to continue playing.
o Playback State/Tag Allows you to continue playback from a state tag, or
scroll through the state tags. Enter a value between 1 and the total number
of state tags using the numeric keypad, ▲|▼ arrows, or the rotary knob.
Learn more in About State and User Tags on page 121.