186 FieldFox User’s Guide
How to set Power ON
Press System 7
Then System Configuration
Then Power ON
Then choose from the following:
o Auto The FieldFox will power ON when a charged battery or the DC Adapter
is inserted.
o Manual The FieldFox will power ON only when the power button is pressed.
Service Diagnostics
The Service diagnostics menu is generally used to display service-related
information. To access these menu items, press System 7 then Service
Diagnostics.
System Information
The System information table shows important information about your FieldFox.
The following is the most useful information:
Model Number – FieldFox model
Serial Number – Identification number of your FieldFox
Firmware Release – The currently installed version of software. Check to see
if you have the latest firmware at: www.agilent.com/find/fieldfoxsupport
Network Identity – The network name and current IP address of your
FieldFox.
NA Factory Cal - The NA Factory (CalReady) Calibration shows the date and
time that the factory cal was performed for each test port and the Thru
connection. The format is P1 <date time>, P2 <date time>, P1-P2 <date time>.
The factory calibration is updated when you send your FieldFox to Agilent for
Instrument Calibration. Learn more on page 215.
Error Log
The Error Log shows the information that has appeared on the FieldFox screen.
The most recent information is at the top of the table.
Press Clear Errors to erase this information.
Battery
Learn about this table on page 188.
Internal Temperatures
Learn all about this table and the importance of the internal FieldFox
temperatures on page 12.
To Next Page
Loading...
Need help?
General
