Agilent Technologies FieldFox N9913A - SA Mode Settings

76 FieldFox User’s Guide
Zero Span Measurements ..................................... 93
Triggering ................................................................ 94
FFT Gating (Option 238) ...................................... 97
Single/Continuous/Restart .................................. 98
Points ....................................................................... 98
Trace Display States .............................................. 99
Average Type .......................................................... 99
Average Count ...................................................... 100
InstAlign Amplitude Alignment ........................ 100
RF Burst Alignment............................................. 101
Detection Method ................................................. 102
Display Line .......................................................... 103
Noise Marker ........................................................ 103
Band/Interval Power Marker ............................. 104
Frequency Counter at Marker ........................... 105
Audio Beep at Marker Power ............................ 105
Channel Measurements ...................................... 106
o Channel Power
o Occupied Bandwidth
o Adjacent Channel Power Ratio
See Also
Interference Analyzer
Spectrogram Display ........................................... 115
Waterfall Display ................................................. 118
Record / Playback ................................................ 119
Optional settings
Markers .................................................................. 148
Limit Lines ............................................................ 158
Save Measurement Settings and Results ......... 164
SA Mode Settings
Select SA Mode before making any setting in this chapter.
Because there is no calibration, these settings can be made in any order.
How to select SA Mode
 Press Mode_.
 Then SA.