134 FieldFox User’s Guide
Power Meter Mode
Power Meter measurements, available with Option 302, are made with Agilent
USB power sensors. Power readings are displayed on the FieldFox screen.
In this Chapter
Supported Power Sensors .................................. 134
How to Connect the Power Sensor ................... 135
Average/Peak ....................................................... 135
Zeroing ................................................................... 135
Set Frequency ....................................................... 136
Set Scale ................................................................ 136
Set Relative and Offset Power ........................... 137
Set Display Units ................................................. 138
Set Averaging........................................................ 138
Single/Continuous ............................................... 138
Step Detection Mode ........................................... 139
Set Limits .............................................................. 139
Supported Power Sensors
Power Meter measurements are made using any of the Agilent U2000 Series and
U2020 X-Series USB Power Sensors.
NOTE The FieldFox does NOT support the following Agilent USB Power Sensor
features: External Triggering (Time Gated Burst Power Measurement), Power
Sweep Operation, and Frequency Sweep Operation. External Zeroing is NOT
allowed on the U2020 X-series Power Sensors.
To Next Page
Loading...
