Agilent Technologies FieldFox N9913A - File Management; Save Measurement Settings and Results

164 FieldFox User’s Guide
File Management
The FieldFox can save any of the following types of files:
 Current settings and calibration
 Trace data (*csv and *.S1P)
 Picture of the FieldFox screen
In addition, files can be saved to the internal memory, a USB Flash drive, or a
microSD card.
In this Chapter
Save Files .............................................................. 164
Recall Files ............................................................ 166
Set File Type and Device ................................... 166
Manage Files ........................................................ 168
Manage Folders ................................................... 169
Edit Keywords ...................................................... 169
Prefixes for Filenames ....................................... 170
See Also
Erase User Data ................................................... 185
Saving and Recalling Files
NOTE FieldFox State files are intended to be recalled on the same instrument model on
which they were saved. Sometimes you may able to recall them within model
families. An error will result when trying to recall a state file that was saved on
a different model family.
The FieldFox model families are:
 N991x (VNA/SA) model family
 N992x (VNA) model family
 N993x (SA) model family
Save Files
How to Save a File
 Press Save/Recall 9
 Then Save
 At the top of the current ‘labeler’ screen (see following image) check the File
Type to save and Device (Internal, USB, Storage Card) to which the file is
saved. Learn how to change these settings on page 166.
 Then use the labeler to specify a filename.