Agilent Technologies FieldFox N9913A - Page 165

File Management 165
How to use the FieldFox labeler
The FieldFox labeler is used to edit or change the current filename. It is also used
for many other labeling functions, such as creating a title, prefix, and keyword to
display on the FieldFox screen.
 Press Select to add the cursor character to the end of the existing filename.
 Press Backspace to erase the last character from the current filename.
 Press Clear to erase the current filename.
 The preselected keywords (File, Site, and so forth) can be selected just like a
single character. These keywords can also be edited. Learn more on page 169.
The FieldFox labeler. The current filename is GF2.. The cursor is on the custom GF
keyword. The file will be saved to USB (flash drive). File Type is “Picture”.
How to move the cursor
 Use the rotary knob to move cursor on the same row. The cursor will change
rows when it comes to a row end.
 Use the ▲|▼ arrows to move the cursor up and down the rows.
When the current filename is complete
 Press Done to save the file to the specified filename. If the filename already
exists, a warning is displayed.
 Press Cancel to close the labeler without saving a file.
 If the filename already exists, you are prompted to choose from the following:
o Press Yes to overwrite the existing file.
o Press Cancel to edit the filename.