R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
14.3.2. RTSP Stream Setting
You can select the video codec format for the RTSP stream for the
monitoring and configure video resolution and bit-rate etc., based on your
actual network environment on the web Intercom > RTSP > RTSP stream
interface.
Parameter Set-up:
Video Codec: select between two types of codec options: H.264 and
Mjpeg according to your need.
Video Resolution: select video resolutions among seven options: QCIF,
QVGA, CIF, VGA, 4CIF, 720P, 1080P. The default video resolution is 720P.
and the video from the door phone might not be able to be shown in the
indoor monitor if the resolution is set higher than 720P.
Video Framerate: 25fps is the video frame rate by default.
Video Bitrate: select video bit-rate among six options: 128 kbps,
256kbps, 512kbps, 1024kbps, 2048 kbps, 4096kbps according to your
network environment. The default video bit-rate is 2048 kbps.
2nd Video Resolution: select video resolution for the second video
stream channel. While the default video solution is VGA.
2nd Framerate: 25fps is the video frame rate by default for the second
video stream channel.