R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
the time schedule.
LED Type: you can see the LED type “Auto” “ON” “OFF” “Schedule” you
selected.
Threshold: refers to the current light intensity indicated by the
photo-resistor value. The higher photo-resistor values correspond
conversely to the lower light intensity and vice versa. The default
photo-resistor value (Threshold) is “33”, however, you can tap the icon
several times in order to obtain the actual photo-resistor value in a
specific environment (the value fluctuation is about 5), and the value is
what you based on to configure the minimum and maximum
photo-resistor values.
Min/Max Photoresistor: set the minimum and maximum photoresistor
value based on the current actual photo-resistor value detected to
control the ON-OFF of the LED light. You can set the maximum
photoresistor value for the IR LED to be turned on and the minimum value
for it to be turned off. While the default Minimum and maximum
photoresistor value is “200” and “500” respectively.
7.2. Infrared LED Setting on the Web Interface
You can also select the LED type on the device web Intercom > LED Setting >
LED Fill Light interface if needed.
Note:
T
hreshold value will not be shown on the screen unless you change
the LED type to either “ Auto” or “ Schedule”.
To Next Page
Loading...
Need help?
General
