R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
technical support.
16.2.PCAP for Debugging
PCAP in R29 series door phone is used to capture the data package going in
and out of the devices for debugging and troubleshooting purpose. You can
set up the PCAP on the device web Upgrade > Advanced > PCAP interface
properly before using it.
Parameter Set-up:
Specific Port: select the specific ports from 1-65535 so that only the
data packet from the specific port can be captured. You can leave the
field blank by default.
PCAP: click Start tab and Stop tab to capture a certain range of data
packets before clicking Export tab to export the data packets to your
Local PC.
PCAP Auto Refresh: select “Enable” or “ Disable” to turn on or turn off the
PCAP auto fresh function. If you set it as “Enable” then the PCAP will
continue to capture data packet even after the data packets reached their
50M maximum in capacity. If you set it as “Disable” the PCAP will stop
data packet capturing when the data packet captured reached the
maximum capturing capacity of 1MB.
To Next Page
Loading...
Need help?
General
