R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
9.Intercom Call Configuration
Intercom call in the device can be configured to allow you to perform a
variety of customized intercom calls such as IP call and SIP call for different
application scenarios.
9.1. IP call & IP Call Configuration
IP calls can be made directly on the intercom device by entering the IP
number on the device. And you can also disable the direct IP call if you allow
no IP call to be made on the device web Phone > Call Feature > Direct IP
interface.
Parameter Set-up:
Enabled: click “Enable” or “Disable” to turn the direct IP call on or off. For
example, if you do not allow direct IP call to be made on the device, you
can click “disable” to terminate the function.
Direct IP Port: the direct IP Port is “5060” by default with the port range
from 1-65535. And you enter any values within the range other than the
5060, you are required to check if the value entered is consistent with the
corresponding value on the device you wish to establish a data
transmission with.
9.2. SIP Call &SIP Call Configuration
You can make SIP calls (Session Initiation Protocol) in the same way as you
do for making the IP calls on the device. However, SIP call parameters related
to its account, server, and transport type need to be configured first before
you can make calls on the device.
To Next Page
Loading...
Need help?
General
