Akuvox R29 Series - Keyking Setting; Akuvox EC32 Lift Controller

R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
161
Note:
 Dummy card numbers can not be sent if “OSDP” is not selected in
the lift control list field.
21.6.KeyKing Setting
To integrate the KeyKing lift controller, you are required to set up the KeyKing
address obtained from your solution provider. You can navigate to Lift
Control > KeyKing Advance Setting.
Parameter Set-up:
 KeyKing Address: select the KeyKing address provided by your solution
provider. The address number must be identical to the address number
on the lift controller board.
21.7.Akuvox EC32 Lift Controller
You are required to configure Akuvox EC32 before you can connect the door
phone to the lift controller. You can navigate to Lift Control > Akuvox EC32 &
ZKT Advance Setting.