R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
21.8.ZKT Lift Controller
You are required to configure the ZKteco lift controller before you can
connect the door phone to the lift controller. You can navigate to Lift
Control > Akuvox EC32 & ZKT Advance Setting.
Parameter Set-up:
Server IP: enter the IP address of the ZKTeco controller server.
Port: enter the port of ZKTeco controller server.
Timeout: enter the lift controller timeout. For example, if you enter 30
seconds, then you have to press the floor buttons on the lift controller in
30 seconds after you, for example, swipe the card, otherwise, the button
will become invalid.
21.9.Mobile Community
You can connect the door phone to the third party QR code server for QR
code verification. When you access the door using a QR code, the QR code
will be sent to the QR code server for verification before granting you the
access permission. This feature is applied to the devices not deployed in the
SmartPlus platform for the QR code door access. You can navigate to
Intercom > Relay > Mobile Community.
To Next Page
Loading...
Need help?
General
