R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
“Manual” if you want to awake the screen by touching the screen. Select
video detection if you want to awake the screen by video-based motion
detection.
7.7.2.2. Await Screen Setting on the Web Interface
You can also conduct the await screen configuration on the web
Intercom > Advanced > Standby Interface Display interface.
Parameter Set-up:
Screensaver Mode: enable the screen saver mode if needed.
Screensaver Time: set up the screen saver display duration from 5
second to 2 hours. The screensaver display will start when the device
goes into sleep mode.
Sleep: set up the sleep mode timing from 5 seconds to 30 min. For
example, if you set it “10” seconds, then the device will go into sleep
mode when detects no approaching object or no operation on the device.
When the screen saver is disabled, the device screen will be turned off.
Wake Mode: select the method for the screen awake mode. Select “IR
Detection” if you want to awake the screen via IR detection. Select
“Manual” if you want to awake the screen by touching the screen. Select
video detection if you want to awake the screen by video-based motion
detection.
7.7.3.Upload Screen Saver
To Next Page
Loading...
Need help?
General
