R29X Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
Heat Threshold: set up the heat control threshold from -100 ℃ to 100 ℃.
For example, if you set it at 40 ℃, then the device LCD screen will be
automatically heated up to 40 ℃ when the LCD screen is detected lower
than 40 ℃. The device will stop the automatic heat-up when the
temperature reached the threshold value.
Interval: set up the automatic temperature detection interval for the
device temperature. The device has a built-in temperature sensor.
7.6. LED White Light Setting
LED White light is used to reinforce the lighting for facial recognition as well
as for the QR code access as needed in the dark environment. You can set
the white light function properly on the device web Intercom > Advanced >
White Light interface.
Parameter Set-up:
Mode: enable the white light mode.
Max White Light Value: set the white light value from 0-255, and the
default white light value is “50”.
White Light PWM Value: set the white light PWM value from 0-100. PWM
value affects the white light brightness that is set with the same white
light value. For example, if the white light value remains the same, and
you bring up the PWM value, you will get brighter white light. In short, the
higher the PMW value is the brighter the light is.
7.7. Screen Display configuration
R29 series door phone allow you to enjoy a variety of screen displays to
enrich your visual and operational experience through the customized setting
To Next Page
Loading...
Need help?
General
