NOTE
If the GPS receiver is installed on the implement, the
position of the GPS receiver must be entered through
the implement geometry.
A: Transverse offset of the GPS receiver relative to
the attachment point
B: Longitudinal offset of the GPS receiver relative
to the attachment point
5. If the GPS receiver is installed on the implement,
enter the values for A and B under "Implement
geometry".
2
Configuring non-ISOBUS implements
2.1
Creating non-ISOBUS implements
1. In the main menu, select .
2. Under "Implements", select .
3. Enter the implement name.
4. Confirm with
.
CMS-T-00000318-D.1
CMS-T-00000321-C.1
K | Configuring implements | Configuring non-ISOBUS implements
MG6010-EN-GB | G.1 | 13.12.2018
39
To Next Page
Loading...
