1. In the main menu, select .
2. Select the desired tractor under "Tractors".
3. Select "Sensors".
4. Select "PTO shaft".
5. If the PTO shaft speed should be sent,
select "Send signal".
6. Enter the value for the correct PTO shaft speed
under "Pulses per revolution".
3.5
Configuring the working position sensor
3.5.1
Configuring digital working position sensors
1. In the main menu, select .
2. Select the desired tractor under "Tractors".
3. Select "Sensors".
CMS-T-00000315-C.1
CMS-T-00000312-C.1
L | Configuring tractors | Configuring the tractor sensors
MG6010-EN-GB | G.1 | 13.12.2018
49
To Next Page
Loading...
Need help?
General
