5.3.1.2 - Accumulate
Accumulate mode allows user to ‘add together’ in the computer memory the data from a number of scans to create an
‘accumulated scan’ e.g.:
The following parameters can be entered in the Setup Acquisition dialog box:
• Exposure Time
• Accumulated Cycle Time: The period in seconds between each scan. This parameter is only available when
internal triggering is selected
• No. of Accumulations: The number of scans to be added together
Note: This mode can be used to effectively improve the acquisition signal to noise ratio.
Pre-Acquisition Setup - CCD
To Next Page
Loading...