Pre Acquisition Setup - Data
5.3.8.3 - Auto-Save
Auto-Save allows user to set parameters and controls for the auto saving of acquisition les thus removing the worry of
lost data and les. Selection of this mode is accessible under the Auto-Save tab on the Setup Acquisition dialog box.
The Auto-Save dialog box appears, e.g.:
If selected, acquisitions will be saved automatically after each individual one is completed. Each subsequent auto-saved
le will over-write the previously auto-saved one.
In the Auto-Save dialog box, a Stem Name may be entered. This is the main root of the name that the acquisition is to
be saved as.
The Stem Name can be appended with a number of details, e.g.:
• Operatorname(suppliedbyuser)
• Computername
• Cameratype
• Date
• Time
An auto-increment On/Off tick box allows a number to also be entered to the main stem name. This number is
automatically incremented each time a le is saved.
Any combination of these may be selected by activating the relevant tick box, e.g.:
Note: This function will only auto-save single scan, kinetic series or accumulated images.
To Next Page
Loading...
Need help?
General
