Anser X1 - Page 65

ANSER CODING INC. 54 X1 User Interface
Table 1-11. Scan & Print Settings Definition
Parameter
Definition
Device
- ttyS01 stands for RS-232 and ttyS04 for RS-485 when no device is connected or the
scanner is not setup as virtual COM or CDC.
- ttyACM0 or ttyUSB0 will appear when X1 detects the serial device.
Number of Scan
- Perform multiple scans, data is stored to variable1, variable2, up to 20.
- In the upper right corner of the home page,  will show
"Current Scan Number / Number of Scan
Note: Iposition and length for serial data is not supported.
Number of Print
Set a count for how many times to print the scan data.
0: Unlimited number of prints.
1-50: Limited number of prints.
Variable File
Off: 
Variable table list: Select one table to save the data.
Position
Set the starting position from where to start capturing part of data stream.
Length
Set the size of how many characters the system wants to capture from the data stream.
Importing Data
A preview of the scan data before setting position and length.
Formatting Data
View data after it is split into multiple variables according to position and length.
.