Arbiter Systems 1084A - Specifications; C.10.3 Specifications

C.10 Option 17: Parallel BCD Output and Second RS-232C Port 129
C.10.3 Specifications
General
Output Connector: 50 contact;Amphenol P/N 850-57L-40500-2700 or equivalent.
Mating Connectors:
Plastic: Amphenol P/N 850-57F-30500-20
Metal Shell: Amphenol P/N 850-57FE-30500-20
Parallel BCD Output
Data Bus Width: 42 bits. For weighting, refer to Table 1.
Output Type: High-Speed CMOS, buffered, (74HCXXX), 0 to 5 volts.
Time Data Format: UTC or Local time data; corresponds to setting for IRIG
time data (see 1084A/B/C Operation Manual).
Time Accuracy: Rising edge delay of 100 nS maximum (1 mS bit), relative to
1 PPS output rising edge.
Analog Outputs
Output Type: Operational Amplifier (LF353) output, with 562-ohm series
resistor.
Pin Numbers: Output 1: pin 22
Output 2: pin 47
IRIG-B, Modulated: IRIG format B time code, modulated onto 1 kHz 10 Vpp sine
wave carrier.
Deviation: Model 1088B Only; ±5 volts analog, corresponding to 1 PPS
deviation channel A or B.