Arbiter Systems 1084A User Manual

44 The Setup Menus
6.7.6 Prog Pulse, Slow Code
Slow code is a programmable pulse mode that causes the output voltage to be held high and go
low for six seconds on the day, four seconds on the hour and two seconds on the minute. Note:
make sure to set the Pulse Polarity to negative for normal operation. See Section 6.7.7. RS-232C:
see Section 9.2.10.
Figure 6.14: Slow Code Setup

Arbiter Systems 1084A Specifications

General

Brand	Arbiter Systems
Model	1084A
Category	Clock
Language	English