Arbiter Systems 1084A - Prog Pulse, Pulse-Per-Hour Mode; Pulse-Per-Hour Setup

6.7 Set Programmable Pulse Mode 41
6.7.3 Prog Pulse, Pulse–Per–Hour Mode
Use the Pulse–Per–Hour mode to generate a pulse every hour, at the number of specified seconds
(from 0 to 3599 seconds) after the hour. Refer to Section 6.7 above for additional detail on the
programmable pulse mode, and entering eumerical values. RS-232C: see Section 9.2.10.
Figure 6.11: Pulse–Per–Hour Setup