Arbiter Systems 1084A User Manual

6.3 Set Local Hour 35
6.3.2 Set Daylight Saving Time (DST)
For automatic changeover, use the AUTO setting described in Figure 6.4. Make sure to determine
the changeover requirements in your locale before trying to adjust these clock settings. The default
setting is for North America, where DST begins on the second Sunday of March at 2 am and ends
on the first Sunday of November at 2 am. Go through each setting and verify that the settings
are valid. To adjust and install values, press the UP/DOWN keys to adjust the desired value and
ENTER key to install that value and proceed to the next setting. RS-232C: see Section 9.2.4.
Figure 6.5: Auto Daylight Saving Setup

Arbiter Systems 1084A Specifications

General

Brand	Arbiter Systems
Model	1084A
Category	Clock
Language	English