Arbiter Systems 1084A - Setting Port Parameters; Setting the Broadcast Mode from Main RS-232; Port Parameter Setup; Broadcast Setup

To Next Page

To Previous Page

6.2 Setting the Main RS-232C Port 33

6.2.1 Setting Port Parameters

Enter this menu from the “Set Main RS-232?” menu; see Figure 6.1. The “Set Port Conﬁg” menu

allows you to conﬁgure any of the RS-232C port parameters from the front panel. Use the UP and

DOWN keys to adjust the parameter values. RS-232C: Port parameters may not be changed from

RS-232C ports. They may only be changed with Models 1084B/C series clocks from the front panel.

Figure 6.2: Port Parameter Setup

6.2.2 Setting the Broadcast Mode from Main RS-232

Enter this menu from the “Set Main RS-232?” menu; see Figure 6.1. The “Set Broadcast Mode”

menu allows you to conﬁgure the Model 1084A/B/C to broadcast ASCII time/date-related data

from the available RS-232C ports. With the UP/DOWN keys select the desired broadcast mode

and press ENTER to immediately start the broadcast. RS-232C: see Section 9.2.1.

Figure 6.3: Broadcast Setup