160
Appendix
Troubleshooting
My telephone doesn’t work at all.
X Make sure the power cord is securely plugged in.
X Make sure that the battery connector is securely plugged into the handset.
X Make sure that the battery is securely installed in the cordless headset.
X Make sure the telephone line cord is securely and rmly plugged into the
telephone base and the telephone wall jack.
X Charge the battery in the cordless handset for at least 11 hours. For optimum
daily performance, return the cordless handset to the charger when not in
use.
X Charge the battery in the cordless headset for at least three hours. For
optimum daily performance, return the cordless headset to its charger when
not in use.
X Reset the headset. Power o the headset and then power it on.
X If the cordless handset battery is depleted, charge the handset for at least
30 minutes before you use it. Refer to page 14 for details.
X Reset the telephone base. Unplug the electrical power. Wait for
approximately 15 seconds, and then plug it back in. Allow up to one minute
for the handset and telephone base to reset.
X You may need to purchase a new battery. Please refer to
Battery installation and charging (pages 14-16) in this user’s manual.
The display shows No line. I cannot get a dial tone.
X Try all the suggestions mentioned above.
X If the previous suggestions do not work, disconnect the telephone line
cord from your telephone and connect the telephone line cord to another
telephone.
X If there is no dial tone on the other telephone either, your telephone line
cord may be defective. Install a new telephone line cord.
X If changing the telephone line cord does not help, the wall jack (or the
wiring to this wall jack) may be defective. Try using a dierent wall jack in
your home to connect your TL87203 telephone, or contact your telephone
service provider (charges may apply).
To Next Page
Loading...
