8.18.3.3 Command String
With this event you can send by RS232 commands to third party devices. Valid commands are
described in the Communication Protocoles
chapter.
• Type: displays the type of event that is created, in this case Load Preset
• Name: here you can specify a name for the event created
• Attrib: here you can choose between security event or not. See Common Option to learn more
about the security option
_________________________________________
• Next Event: you can specify an event that will be started as soon as this event has finished
_________________________________________
• Command: here you can type in the command to send
• Port Number: here you have to specify on which port the command have to be sent
8.18.3.4 Stop Event
This event have been created in order to be able to stop any event by the means of a trigger.
• Type: displays the type of event that is created, in this case Load Preset
• Name: here you can specify a name for the event created
Ateïs International
Ch. du Dévent, 1024 Ecublens, Switzerland.
Phone : +41 21 881 25 10
67
To Next Page
Loading...
