• Type: display the type of event you are creating or modifying
• Name: here you can specify a name for the event created. Default is Event X
• Priority: here you can adjust the priority of the event. 20 is the lowest, 0 is the highest
• Attrib: here you can specify if this event is a security one or not. See Common Option to learn
more about the security option
______________________________________
• Next Event: here you can select the event to start after the current on is finished
______________________________________
• Active at Start: Ticking this option allows user to close an output contact (Logic Output channel)
in two different manner. Static will close it until the event stop and Pulse will generate a closing
pulse whose length can be defined from 50 to 60000 ms.
• Active at Stop: This option is used to create a closing contact pulse when the event is finished.
The length of the pulse can be defined from 50 to 60000 ms.
To learn more about output relay, please read the How To Use Output Relay
.
______________________________________
• Music Source: here you can choose the music source you want to switch on/off
______________________________________
• Zone Selection: here you can specify the zone(s) where the music will be played and stopped
Ateïs International
Ch. du Dévent, 1024 Ecublens, Switzerland.
Phone : +41 21 881 25 10
79
To Next Page
Loading...
