2.Lubricate the steering vertical column holder
¢Ùand seal ring¢Úduring installing the steer-
ing vertical column welding.
3.Installment
Install the seal ring ¢Ùto the steering vertical
column welding, then install bushing¢Ú, finally
install the steering vertical column holder¢Û.
Caution:
Never damage the seal ring when installing.
4.Installment
When installing the steering vertical column
holder and steering vertical column welding take
them as unit ¢Ù.
In order to ensure the correct circuit of brake
cable and wire, never damage and wind the
cables and wires.
5.Installment of left and right tension rod¢Ú
Make sure that the ball pin at the side of
scraped marking connect with the front seat
assy of front brake.
6.tighten up the nut of ball pin assy.
Attached:Nut torque :25Nm
Warning
Caution
- 98 -
To Next Page
Loading...
