1. Reverse operation system
1) Mount:
¡¤Reverse operation shaft ¢Ù
¡¤Operation plate ¢Ú
¡¤Reverse control lever ¢Û
¡¤Circlip ¢Ü
Mount the above on the rear driving cover.
Mount the reverse fork shaft into the hole of the
reverse fork and then pull out the locating pin
and take it out.
¡¤Check if the fork is working.
Caution
2) Mount:
¡¤Compressing spring ¢Ù(on reverse gear fork
¢Ü)
¡¤Steel ball ¢Ú
Mount a positioning set pin ¢Û into the fork
first for fixing the steel ball and spring, that is
easy to mount the fork pin into fork.
3) Lubrication
Apply lubrication oil(SAE20W/40) in the inner
diameter of fork and pin.
4) Mount
¡¤Reverse gear fork shaft (With O-ring)
¡¤Mount the reverse gear fork pin ¢Ù into the
hole of rear driving cover ¢Û
¡¤Reverse gear fork ¢Ú
Caution
¢Ü
¢Û
¢Ù
¢Ú
¢Û
¢Ù
¢Ú
- 188 -
(III) Assembly of left crankcase
To Next Page
Loading...
