4.Install
Brake shoe assy
Do not apply lubricating grease on brake fric-
tion wafer.
5.Connect
a.front brake air pipe.
b. connect the front brake cable with brake
cover.
6.Install (as shown in figure)
¢ÙCirclip
¢ÚSpring
¢ÛCirclip
¢ÜSpring
¢ÝPin
¢ÞAdjusting nut
7.Install(as shown in figure)
¢ÙFront brake hub
¢ÚGasket, O-ring 17 ¡Á1.8G
¢ÛWasher
¢ÜSlotted nut (torque:70N.m)
8.Install
¢ÙSplit pin
After the torque is fixed, do not loosen the slot-
ted nut. If the concave slot of the slotted nut
does not aim at pin hole of the screw column,
aim them by tightening up the slotted nut.
Should use new and complete split pin.
Caution
Warning
- 82 -
To Next Page
Loading...
