Audi Q7 2007 - Page 147

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1 Removing and installing parts of lubrication system
141
6
– Remove bolts -4- and lower subframe carefully using en-
gine and gearbox jack -V.A.G 1383 A-.
– Unscrew bolts -3- for engine cross member and position
engine cross member onto subframe.
Disregard items marked -1- and -2-.
– Unplug electrical connector at oil level and oil temperature
sender -G266- -item 1-.
– Place used oil collection and extraction unit -V.A.G 1782-
under engine.
– Drain off engine oil.
– Unbolt bottom section of sump -arrow-.
There will still be some oil in the bottom section of sump when
removing.
Installing
Renew seals.
– Remove sealant residue from bottom section of sump and
top section of sump with rotating plastic brush or similar.
– Clean sealing surfaces; they must be free of oil and grease.
– Cut off tube nozzle at front marking (nozzle approx. 1.5
mm ∅).
WARNING!
Wear safety goggles.
Note
Note
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259