Audi Q7 2007 - Removing and Installing Sump (Top Section)

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1 Removing and installing parts of lubrication system
145
6
1.5 Removing and installing sump (top section)
Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
♦ Safety goggles
♦ Electric drill with plastic brush attachment
♦ Sealant ⇒ Parts catalogue
Removing
– Unscrew bolts and take off front noise insulation -1- and
rear noise insulation -2-.
– Place used oil collection and extraction unit -V.A.G 1782-
under engine.
– Drain off engine oil.
– Remove engine ⇒ page 4.
– Separate engine from gearbox ⇒ page 21.
– Secure engine to engine stand ⇒ page 29.
– Remove timing chain covers ⇒ page 59.
– Remove chain for oil pump and balance shaft ⇒ page 85.
– Remove sealing flange (front) ⇒ page 43.
– Remove sump (bottom section) ⇒ page 138.
– Remove oil pump ⇒ page 142.
– Remove bolts -1 … 4- for sump (top section).
– Press sump (top section) off spring pins on cylinder block.
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259