Audi Q7 2007 - 2.14 Removing and Installing Balance Shaft

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
2 Servicing work on timing chain end
89
6
2.14 Removing and installing balance shaft
Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
Removing
– Unscrew bolts and take off front noise insulation -1- and
rear noise insulation -2-.
– Place used oil collection and extraction unit -V.A.G 1782-
under engine.
– Drain off engine oil.
– Remove engine ⇒ page 4.
– Separate engine from gearbox ⇒ page 21.
– Secure engine to engine stand ⇒ page 29. Alternatively,
leave engine in position on scissor-type assembly platform
-VAS 6131-.
– Remove sealing flange (front) ⇒ page 43.
– Remove drive plate ⇒ page 54.
– Remove timing chain covers ⇒ page 59.
– Attach adapter -T40049- at rear end of crankshaft using
two old securing bolts for drive plate.
Ignore -arrow-.
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259