Audi Q7 2007 Workshop Manual

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1 Removing and installing parts of lubrication system
157
6
– Screw oil pressure switch -2- into oil pressure tester
-V.A.G 1342-.
Checking oil pressure switch
– Connect brown wire -1- of oil pressure tester to earth (“–
”).
– Connect voltage tester -V.A.G 1527 B- with test leads
from auxiliary measuring set -V.A.G 1594 C- to oil pres-
sure switch and battery positive (“+”).
• LED should not light up.
If LED lights up now:
– Renew oil pressure switch.
– Start engine.
Observe tester and LED while starting, as switching point of
oil pressure switch may already be exceeded when starting.
• Test lamp should light up at 0.7 ... 1.1 bar.
If LED does not light up:
– Renew oil pressure switch.
Checking oil pressure
– Start engine.
• Minimum oil pressure at idling speed: 1.8 bar
• Minimum oil pressure at 2000 rpm: 4.0 bar
The pressure relief valve or oil pump is defective if the speci-
fications are not attained.
– Renew oil pump ⇒ page 142.
Assembling
– Install oil pressure switch -F1- ⇒ page 154.
1.13 Engine oil
Viscosity grades and oil specifications ⇒ Maintenance;
Booklet 803
1.14 Checking oil level
Procedure
• Engine oil temperature at least 60 °C.
• Vehicle must be level (horizontal)
• Wait a few minutes after switching off the engine to allow
the oil to flow back into the sump.
– Pull out the dipstick, wipe off with a clean cloth and insert
it again as far as it will go.
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259

Audi Q7 2007 Specifications

General

Brand	Audi
Model	Q7 2007
Category	Automobile
Language	English