Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 26 – Exhaust system
6
204
Installation position of clamp
– Install clamp with bolts at the bottom.
1.2 Renewing tailpipes
Procedure
– Remove tailpipe -arrow-.
– Fit tailpipe onto rear silencer and align.
– Check clearance between tailpipes and bumper on both
sides.
• Dimension -x- (left-side) = dimension -x- (right-side)
1.3 Removing and installing starter catalytic
converter
Removing
All cable ties which are released or cut open when removing
must be fitted in the same position when installing.
– Unscrew bolts and take off front noise insulation -1- and
rear noise insulation -2-.
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
To Next Page
Loading...
