Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 17 – Lubrication
6
154
– Unscrew bolts -1 ... 8-.
– Take out mounting plate with oil cooler, pressure control
valve and oil filter housing
Installing
Installation is carried out in the reverse order; note the follow-
ing:
Renew gaskets, seals and O-rings.
– Tighten bolts securing mounting plate from the inside out-
wards.
– Install exhaust gas recirculation cooler ⇒ page 221.
– Install high-pressure pump ⇒ Rep. Gr. 23.
– Install toothed belt for high-pressure pump ⇒ page 48.
– Install coolant pipe (rear) ⇒ page 181.
– Install bottom section of intake manifold (left and right)
⇒ Rep. Gr. 23.
– Install intake manifold (top section) ⇒ Rep. Gr. 23.
– Fill up with engine oil and check oil level ⇒ page 157.
– Fill cooling system ⇒ page 162.
Tightening torque
1.11 Removing and installing oil pressure switch
-F1-
Removing
– Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
Component Nm
Mounting plate to cylinder block 9
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ:1398556747 电话:18218750259