Audi Q7 2007 Workshop Manual

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 17 – Lubrication
6
142
– Apply bead of sealant -arrow- onto clean sealing surface of
sump (bottom section) as illustrated.
• Width of sealant bead: 2 mm.
♦ The sealant bead must not be thicker than specified, oth-
erwise excess sealant could enter the sump and clog the
strainer in the oil pump.
♦ The sump (bottom section) must be installed within 5 min-
utes after applying sealant.
– Fit sump (bottom section) and tighten all bolts initially to
5 Nm in diagonal sequence.
– Tighten bolts on sump (bottom section) in diagonal se-
quence.
– Install subframe ⇒ Rep. Gr. 40.
– Install air cleaner housing ⇒ Rep. Gr. 23.
– Install coolant pipe (left-side) ⇒ page 174.
– Install poly V-belt tensioner ⇒ page 40.
– Install poly V-belt ⇒ page 39.
– Fill up with engine oil and check oil level ⇒ page 157.
Tightening torques
1.3 Removing and installing oil pump
Special tools and workshop equipment required
♦ Long-nose grip pliers -VAS 6226-
Component Nm
Sump (bottom section) to sump (top sec-
tion)
9
Engine cross member to longitudinal mem-
ber
120 + 180°
1)2)
Engine mounting to engine support 75
Oil drain plug 50
•
1)
Renew bolts.
•
2)
180° = one half turn.
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259

Audi Q7 2007 Specifications

General

Brand	Audi
Model	Q7 2007
Category	Automobile
Language	English