Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 10 – Removing and installing engine
6
32
– Remove bolts -1 ... 4- on left and right and detach engine
supports.
Illustration shows engine support (left-side).
– Using support bracket for V6 TDI engine -VAS 6095/1-4-,
secure engine to engine and gearbox support -VAS 6095-
as shown in the illustration.
1.4 Installing engine
♦ Renew self-locking nuts and bolts when performing assem-
bly work.
♦ Renew bolts which are tightened to a specified angle as
well as oil seals and gaskets.
♦ Hose connections and hoses for charge air system must be
free of oil and grease before assembly.
♦ Secure all hose connections with the correct type of hose
clips (same as original equipment) ⇒ Parts catalogue.
♦ Fit all cable ties in the original positions when installing.
– Install engine supports (left and right).
– Check whether dowel sleeves for centring the engine/gear-
box assembly are fitted in the cylinder block; install dowel
sleeves if necessary.
Bearing bush for torque converter
– On vehicles with automatic gearbox, check that bearing
bush -arrow- is inserted in rear of crankshaft. Drive in bear-
ing bush if necessary.
Note
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
To Next Page
Loading...
Need help?
General
