Audi Q7 2007 - 6.2 Wheel Bearing Housing, Removing and Installing

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 19 – Cooling
6
164
– Connect coolant hose -1- (bottom right) at radiator.
– Connect coolant hose -arrow- at coolant pipe (left-side).
– Fill reservoir -VAS 6096/1- with at least 12 litres of
premixed coolant (based on recommended ratio):
• “G12+” (40 %) and water (60 %) for frost protection to -
25 °C.
• “G12+” (50 %) and water (50 %) for frost protection to -
35 °C
• “G12+” (60 %) and water (40 %) for frost protection to -
40 °C
– Screw adapter -V.A.G 1274/8- onto coolant expansion
tank.
– Attach cooling system charge unit -VAS 6096- onto
adapter -V.A.G 1274/8-.
– Run vent hose -1- into a small container -2-. (The vented
air draws along a small amount of coolant, which should
be collected.)
– Close the two valves -A- and -B- by setting lever at right
angle to direction of flow.
– Connect hose -3- to compressed air.
• Pressure: 6 ... 10 bar.
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259