Audi Q7 2007 Workshop Manual

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
1 Removing and installing parts of cooling system
175
6
– Place drip tray for workshop hoist -VAS 6208- under en-
gine.
– Disconnect coolant hose -arrow- from coolant pipe (left-
side) and drain off coolant.
– Unscrew bolts -1 … 5- and remove bracket for ancillaries.
– Unscrew bolt -arrow- and remove coolant pipe (left-side)
from bracket for ancillaries.
Installing
Installation is carried out in the reverse order; note the follow-
ing:
♦ Renew seal and O-ring.
♦ Secure all hose connections with the correct type of hose
clips (same as original equipment) ⇒ Parts catalogue.
– Before installing, clean and smoothen sealing surface for
seal and O-ring.
– Lubricate new seal and new O-ring with “G12+” and slide
onto coolant pipe.
– Install air conditioner compressor ⇒ Rep. Gr. 87.
– Install power steering pump ⇒ Rep. Gr. 48.
– Fill cooling system ⇒ page 162.
Tightening torques
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259

Audi Q7 2007 Specifications

General

Brand	Audi
Model	Q7 2007
Category	Automobile
Language	English