Audi Q7 2007 Workshop Manual

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 13 – Crankshaft group
6
42
♦ Assembly appliance -T40048- with -T40048/4-
Procedure
– Remove vibration damper ⇒ page 40.
– Adjust inner part of oil seal extractor -T40019- so that it is
level with the outer part and lock in position with knurled
screw.
– Lubricate threaded head of oil seal extractor, place it in po-
sition and screw it into oil seal as far as possible (applying
firm pressure).
– Loosen knurled screw and turn inner part against crank-
shaft until the oil seal is pulled out.
– Clamp flats of oil seal extractor in vice.
– Remove oil seal with pliers.
– Clean running surface and sealing surface.
– Fit assembly aid -T40048/1- onto assembly sleeve
-T40048/2- and slide oil seal -1- onto assembly sleeve.
– Take off assembly aid.
– Fit assembly sleeve -T40048/2- on crankshaft and slide oil
seal -1- into sealing surface in engine.
Leave assembly sleeve -T40048/2- in position on crankshaft
for pressing in seal.
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259

Audi Q7 2007 Specifications

General

Brand	Audi
Model	Q7 2007
Category	Automobile
Language	English