Audi Q7 2007 - Page 50

Audi Q7 2007 !
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
Repair Group 13 – Crankshaft group
6
44
– Pry off cover from idler roller for poly V-belt.
– Unscrew bolt -arrow- and detach idler roller from front
sealing flange.
– If fitted, detach noise insulation panel at front sealing
flange -arrows-.
– Remove bolts.
– Pull off front sealing flange (right-side first -arrows 1-, then
left-side -arrows 2-).
– Drive out oil seal with sealing flange removed.
Installing
Renew gaskets, seals and O-rings.
– Remove old sealant from grooves in sealing flange and
from sealing surfaces.
– Remove remaining sealant from sealing flange and cylinder
block/sump (top section) with rotating plastic brush or sim-
ilar.
– Clean sealing surfaces; they must be free of oil and grease.
WARNING!
Wear safety goggles.
Note
更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259