Parameter Description
Web/EMS: VLAN ID
[InterfaceTable_VlanID]
Defines a VLAN ID for the interface. Incoming traffic tagged
with this VLAN ID is routed to the corresponding interface.
Outgoing traffic from this interface is tagged with this VLAN
ID.
Notes:
 To enable VLANs, use the 'VLAN Mode' parameter.
 The VLAN ID must be unique for each interface. .
 VLANs are available only when booting the device from
flash. When booting using BootP/DHCP protocols,
VLANs are disabled for easier maintenance access. In
this scenario, multiple network interface capabilities are
not available.
Web/EMS: Interface Name
[InterfaceTable_InterfaceName]
Defines a name for this interface. It is also displayed in
management interfaces (Web, CLI, and SNMP) for clarity
where it has no functional use.
The valid value is a string of up to 16 characters.
Notes:
 This parameter is mandatory and must be configured.
 The name must be unique for each interface.
Web/EMS: Primary DNS Server IP
address
[InterfaceTable_PrimaryDNSServerI
PAddress]
(Optional) Defines the primary DNS server's IP address (in
dotted-decimal notation), which is used for translating
domain names into IP addresses for the interface.
By default, no IP address is defined.
Web/EMS: Secondary DNS Server IP
address
[InterfaceTable_SecondaryDNSServ
erIPAddress]
(Optional) Defines the secondary DNS server's IP address
(in dotted-decimal notation), which is used for translating
domain names into IP addresses for the interface.
By default, no IP address is defined.
General Parameters
Web/EMS: VLAN Mode
[VLANMode]
Enables VLANs tagging (IEEE 802.1Q).
 [0] Disable (default)
 [1] Enable
Notes:
 For this parameter to take effect, a device reset is
required.
 To operate with multiple network interfaces, VLANs must
be enabled.
 VLANs are available only when booting the device from
flash. When booting using BootP/DHCP protocols,
VLANs are disabled to allow easier maintenance access.
In this scenario, multiple network interface capabilities are
unavailable.
Web/EMS: Native VLAN ID
[VLANNativeVLANID]
Defines the Native VLAN ID. This is the VLAN ID to which
untagged incoming traffic is assigned. Outgoing packets sent
to this VLAN are sent only with a priority tag (VLAN ID = 0).
When the Native VLAN ID is equal to one of the VLAN IDs
listed in the Multiple Interface table (and VLANs are
enabled), untagged incoming traffic is considered as
incoming traffic for that interface. Outgoing traffic sent from
To Next Page
Loading...
Need help?
General
