AudioCodes MediaPack Series MP-11x

User's Manual 478 Document #: LTRT-65417
MP-11x & MP-124
43.2.5 Serial Parameters
The RS-232 serial parameters are described in the table below.
Table 43-14: Serial Parameters
Parameter Description
[DisableRS232]
Enables the device's RS-232 (serial) port.
 [0] = (Default) Enabled
 [1] = Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For how to establish a
serial communication with the device, refer to the Installation Manual.
Note: For this parameter to take effect, a device reset is required.
EMS: Baud Rate
[SerialBaudRate]
Defines the RS-232 baud rate.
The valid values include the following: 1200, 2400, 9600 (default),
14400, 19200, 38400, 57600, or 115200.
Note: For this parameter to take effect, a device reset is required.
EMS: Data
[SerialData]
Defines the RS-232 data bit.
 [7] = 7-bit
 [8] = (Default) 8-bit
Note: For this parameter to take effect, a device reset is required.
EMS: Parity
[SerialParity]
Defines the RS-232 polarity.
 [0] = (Default) None
 [1] = Odd
 [2] = Even
Note: For this parameter to take effect, a device reset is required.
EMS: Stop
[SerialStop]
Defines the RS-232 stop bit.
 [1] = (Default) 1-bit (default)
 [2] = 2-bit
Note: For this parameter to take effect, a device reset is required.
EMS: Flow Control
[SerialFlowControl]
Defines the RS-232 flow control.
 [0] = (Default) None
 [1] = Hardware
Note: For this parameter to take effect, a device reset is required.